Contact Us

Tel:+86-20-87045995-8008

Fax:+86-20-87045995

Mob:+8613360001406

+8618026286956 Allan Lee

+8613380026580 Jessie

E-mail: info@sailai-gz.com

Add: 501, Yunjia Building No.6 Yunjia Street, Yunjing Road, Guanzhou North Avenue, Guangzhou, 510515, China

Home > Knowledge > Content
How to replace the electric motor of piezoelectric photo machine Nov 22, 2018

As we all know, the motor is the core of the operating power of the photo machine, whether the photo machine works normally, the good and bad of the motor plays a very important role. The motor has a long life and is not easy to be damaged. Therefore, we must determine whether the motor is damaged before replacing it. For example, remove the starting cover and start up to observe whether the motor is rotating.      


The motor can be replaced according to the following steps:


1. Disconnect the power supply and use the screwdriver to open the cover of the camera.  


2. Remove the connection line of the motor, and remember where it was connected before pulling out the connection line, otherwise the wrong connection will burn out the motor and cause the main board damage.  


3. Take down the driving belt, pay attention to the process, and do not damage the motor due to excessive force.  


4. Remove the old motor and install the new one.  


It is important to note that the whole installation process can be completed with a screwdriver, and you cannot use a hammer or other hammer, because the photo machine is a sophisticated equipment, and it may cause secondary damage to the photo machine if you receive a shock.